As an alternative to STEP 7, the NCM PC (included on the SIMATIC NET CD) can also be used to perform the configuration. Already configured S7 modules from the STEP 7 project can be transferred directly.

OPC server Configuration of the OPC server is integrated in the STEP 7 Hardware Configuration application.

The SIEMENS products with SNMP functionality listed below have been tested explicitly: SCALANCE X, W, OSM, ESM WinAC/LC with SIMATIC NET CP SIMATIC S7 300/400 CPs and CPUs PROFINET devices, such as ET200 S

Protocols and interfaces The data from any SNMP devices (SNMP V1) is presented at the OPC interfaces.

The SIMATIC NET SNMP OPC server also provides detection of PROFINET devices using the DCP protocol.

Fast online configuring through 'Autodiscovery' In STEP7 V5.3+SP3 and higher, all Ethernet devices can be detected by means of their IP address and/or the SNMP protocol (SNMP V1) and transferred to the configuration.

Integrated into STEP 7 Configuration of the OPC server is integrated in the STEP 7 Hardware Configuration application.

Configuring in 6 languages English, German, French, Italian, Spanish, Chinese.

When installint Simatic NET, look carefully at the required Windows.Īnd when running in a virtual environment, use bridged mode with Extend physical network connectin state. Shortest solutions are to reinstall Simatic NET or install a repair tool from Matrikon. OPC Scout is from Siemens, so I assume you configured the PC Station Configurator properly? Import a XDB or download from Step 7 5.5 or TIA? The best way is to see with wireshark what is going on.

That can be very annoyint to configure properly due DCOM in Windows. Look at most relevant Descarga de opc scout v10 websites out of 14.9 Thousand at. Hi,Last month I configured a comfort panel as OPC UA Server and tested it with OPC Scout V10 of the SIMATIC NET V12 SP2 installation, everything works good!You can.

Siemens opc scout v10 itunes support